May 24, 2023 Leave a message

Titanium alloy cutting

Cutting characteristics
When the hardness of titanium alloy is greater than HB350, cutting is particularly difficult, and when it is less than HB300, it is prone to tool sticking and difficult to cut. However, the hardness of titanium alloys is only one aspect that is difficult to machine, and the key lies in the comprehensive impact of the chemical, physical, and mechanical properties of titanium alloys on their machinability. Titanium alloy has the following cutting characteristics:
(1) Low deformation coefficient: This is a significant feature of titanium alloy cutting, with a deformation coefficient less than or close to 1. The distance of chip sliding friction on the rake face is greatly increased, accelerating tool wear.
(2) High cutting temperature: Due to the small thermal conductivity of titanium alloy (only equivalent to 1/5-1/7 of 45 # steel), the contact length between the chip and the front cutting surface is extremely short, and the heat generated during cutting is not easily transmitted, concentrated in a small range near the cutting area and cutting edge, resulting in high cutting temperature. Under the same cutting conditions, the cutting temperature can be more than twice that of cutting 45 steel.
(3) The cutting force per unit area is large: the main cutting force is about 20% smaller than when cutting steel. Due to the extremely short contact length between the chip and the front cutting surface, the cutting force per unit contact area is greatly increased, which is prone to blade breakage. At the same time, due to the small elastic modulus of titanium alloy, it is easy to produce bending deformation under the action of radial force during processing, causing vibration, increasing tool wear and affecting the accuracy of parts. Therefore, it is required that the process system should have good rigidity.
(4) Severe cold hardening phenomenon: Due to the high chemical activity of titanium, it is easy to absorb oxygen and nitrogen in the air to form a hard and brittle outer skin at high cutting temperatures; At the same time, plastic deformation during the cutting process can also cause surface hardening. The phenomenon of cold hardening not only reduces the fatigue strength of parts, but also aggravates tool wear, which is a very important feature when cutting titanium alloys.
(5) Cutting tools are prone to wear and tear: After the blank is processed by stamping, forging, hot rolling, and other methods, it forms a hard and brittle uneven outer skin, which is prone to blade breakage, making cutting the hard skin the most difficult process in titanium alloy processing. In addition, due to the strong chemical affinity of titanium alloy to tool materials, the tool is prone to adhesive wear under high cutting temperature and high cutting force per unit area conditions. When turning titanium alloys, sometimes the wear on the front cutting surface is even more severe than on the back cutting surface; When the feed rate f<0.1 mm/r, wear mainly occurs on the rear cutting surface; When f>0.2 mm/r, there will be wear on the front blade surface; When using hard alloy cutting tools for precision and semi precision turning, it is more appropriate to have a VBmax of less than 0.4 mm for the wear of the rear cutting surface.
In milling, due to the low thermal conductivity of titanium alloy materials and the extremely short contact length between the chip and the front cutting surface, the heat generated during cutting is not easily transmitted, concentrated in the cutting deformation zone and a small range near the cutting edge. During machining, extremely high cutting temperatures will be generated at the cutting edge, greatly shortening the tool life. For titanium alloy Ti6Al4V, under the allowable conditions of tool strength and machine power, the cutting temperature is a key factor affecting tool life, rather than the magnitude of cutting force.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry