Apr 10, 2024 Leave a message

High Temperature Alloy (GH4169) Cutting And Surface Treatment Technology

 

1. Heat treatment

The suitable heat treatment temperature is 1120-900°C. The cooling method is generally water quenching or other rapid cooling methods. After heat treatment, it should be annealed in time to ensure higher performance. During heat treatment, the material should be heated to the upper limit of the processing temperature. In order to ensure the plasticity during processing, when the deformation reaches 20%, the final treatment temperature should not be lower than 960°C.

2. Cold treatment

Cold treatment should be carried out after solid solution treatment. The treatment hardening rate is higher than that of austenitic stainless steel. Therefore, the manufacturing equipment should be adjusted accordingly, and there should be an intermediate annealing process during the cold treatment process.

2. GH4169 treatment process

The heat treatment of aerospace industry parts is often carried out according to the two systems II and III of the 1.5 specification, namely the standard heat treatment system and the direct aging heat treatment system. If there is a technical basis, other heat treatment systems can also be used. When heat treated according to the standard system, solution treatment can be carried out within the specified temperature range of ±10°C within 950 to 980°C.

3. GH4169 surface treatment process

If necessary, shot peening, hole extrusion strengthening or thread rolling strengthening processes can be used on the surface of the parts to double the service life of the parts under alternating loads. For parts that need to be sprayed with a wear-resistant sealing coating, plasma spraying or explosive spraying can be used. Explosive spraying is better. The explosive spraying coating has high integration strength with the substrate. The coating is dense, hard, low porosity, and resistant to Good grindability.

4. GH4169 cutting and grinding performance

GH4169 alloy has excellent cutting performance. During machining, it is necessary to fully ensure that the arc meets the design specification requirements and has a smooth transition. Sharp corners, pits, scratches and damage are not allowed to occur during machining, assembly or transportation, because when these defects occur, excessive stress concentration can be formed. Serious accidents may occur during application.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry