May 16, 2023 Leave a message

Turbine Blade Cooling Technology

In recent years, with the continuous improvement of the performance of large gas turbines, in order to further reduce the consumption of effective gas, a vapor mist two-phase flow cooling scheme has been proposed, which gradually shifts the cooling of turbine blades from air cooling to air and steam dual working fluid cooling, and has become an increasingly hot research topic. Numerous studies have shown that steam mist cooling has the advantages of fast cooling, high cooling efficiency, small flow resistance, and simple structure, and will play an important role in the cooling of turbine blades for the next generation of high-performance gas turbines. Through numerical simulation of cooling with impact film structure, the average cooling efficiency was significantly improved and the low-temperature zone was significantly extended.
Gas turbines, as large-scale power plants, are widely used in power generation and various industrial fields. Its main performance indicators are system cycle thermal efficiency and output power, both of which increase with the increase of turbine rotor gas inlet temperature; According to calculations, RIT increases by 100 degrees in the range of 1073-1273 K. The output power of gas turbines will increase by 20% to 25%, saving fuel by 6% to 7%. The continuous improvement of gas turbine performance lies in the improvement of RIT, and the increase of RIT should consider the temperature resistance of gas turbine hot end component materials and low NO emissions. RIT is much higher than the melting point of turbine blade metal materials, especially when the next generation of gas turbines will use hydrogen and artificial gas as fuel, and RIT will be higher, so cooling is essential. Advanced cooling technology can enable hot end components to withstand higher operating temperatures, improve the cycle thermal efficiency of gas turbines, extend the service life of gas turbines, and improve the safety and reliability of system operation. According to calculations, if the use temperature of the uncooled guide vane material can reach 1470 K, the internal convective cooling of the guide vane can increase the turbine inlet temperature to 2200 K. It can be seen that conducting research on blade cooling technology is of great significance.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry